The Common Mistakes in the Use of High-pressure blowers
The Common Mistakes in the Use of High-pressure blowers
With its advantages of high pressure and low noise, high-pressure blower plays an important role in ventilation and material transportation. However, some misunderstandings in the use process will often affect the performance of the blower and even shorten its service life. The following misunderstandings need special attention:
Ignoring installation specifications is one of the common problems. Some users did not ensure that the blower was placed horizontally during installation, or the connection with the pipeline was not tight, which led to severe vibration during operation, which not only affected the stability of the blower, but also accelerated the wear of parts. In addition, if the installation location is poorly ventilated and close to the heat source, the heat dissipation of the blower will be blocked, resulting in too high motor temperature, reducing the efficiency of the blower and even causing failure. The correct way is to operate in strict accordance with the installation instructions to ensure that the blower is firmly installed, well ventilated and keeps a safe distance from the heat source.
Improper selection will also bring many problems. Some users blindly choose the blower model without fully considering the actual working conditions. If the selection power is too large, it will cause energy waste and increase the operating cost; If the selection power is too small, it will not meet the work requirements, which will lead to the overload operation of the blower for a long time and accelerate the aging. Therefore, it is necessary to accurately calculate the required air volume and wind pressure, comprehensively evaluate the use environment, and select the suitable high-pressure blower model before type selection.
The lack of daily maintenance is also worthy of vigilance. After long-term operation of high-pressure blower, dust and sundries are easy to accumulate on blades and air inlets. If not cleaned in time, the air volume and pressure of the blower will be affected and the work efficiency will be reduced. Moreover, ignoring the lubrication and maintenance of key components such as bearings will aggravate the wear of components and increase the probability of failure. Proper maintenance should regularly clean the inside of the blower, check and add lubricating oil, and replace worn parts in time to ensure that the fan is in good running condition.
The wrong operation mode can not be ignored. Frequent starting and stopping of the blower will cause the motor to be impacted by large current and shorten the life of the motor; Maintenance or adjustment while the blower is running may also cause safety accidents. When using the high-pressure blower, the operation procedures should be strictly followed to avoid unnecessary start-up and stop, and the maintenance should be carried out after stopping and cutting off power.